A vacuum that suddenly stops picking up usually needs an airflow check before it needs a motor diagnosis. Empty the bin, inspect the filter, separate the wand or hose, and then check the cleaner head. That order isolates the restriction without opening the motor housing or guessing at an electrical fault.

Stop first if the problem looks electrical
Switch the vacuum off and disconnect it from the wall or charger before touching the bin, filter, wand, hose, or brush roll. Stop using it if the plug or cable is damaged, the casing becomes unusually hot, a breaker trips, or there is a burning smell, smoke, crackling, or sparking. Those signs are not an airflow-cleaning job; contact the manufacturer or a qualified repair service.
If the vacuum simply sounds different, pulses, or leaves debris behind, let it cool and follow the external checks below. Keep the model manual nearby because filter locations, washable parts, and drying times vary.

1. Empty the bin before the maximum line
A packed bin leaves less space for air and debris separation. Empty it over a trash container and inspect the inlet where dirt enters the bin. Remove loose debris without inserting metal tools into the appliance. Refit the bin until every latch closes; an incomplete seal can feel like weak suction.
Do not judge the result on a thick rug yet. Test on a small patch of hard floor with the normal power mode. Some cordless models deliberately change suction by mode or floor type, so compare like with like.

2. Check the filter instructions, not a generic washing routine
Manufacturer guidance differs. Dyson identifies a dirty filter as a common cause of reduced performance, while Shark manuals specify water-only rinsing for certain filters and complete air-drying before reinstallation. Confirm that your exact filter is washable. Tap off loose dust outdoors first, rinse only if the manual permits it, and do not add detergent unless instructed.
Allow a washable filter to dry completely in moving room air. Do not speed drying with an oven, microwave, hair dryer, tumble dryer, or direct high heat. A damp filter can restrict airflow and draw moisture toward electrical parts. Reinstall every required filter in its correct orientation; some vacuums will not seal or operate correctly with a filter missing.

3. Separate the airflow path
Detach the floor head and wand or hose according to the manual. Look through each removable section toward a light. A sock, paper scrap, clump of hair, or compacted dust often sits at a bend or connection. Remove only what is accessible without puncturing the hose or pushing a blockage deeper.
Test briefly after reassembly. If suction is strong at the handheld body but weak after the wand is attached, the restriction is downstream. If it remains weak with all external passages clear and a clean, dry filter fitted, stop repeating the same cleaning steps.
4. Treat brush pickup and suction as separate questions
A floor head can leave crumbs behind even when airflow is adequate. With power disconnected, inspect the brush roll and intake opening. Cut or unwind hair only where the manufacturer permits, keep fingers away from sharp edges, and make sure the roll turns freely before refitting the head. Do not run a motorized head while your hands are near it.
Afterward, test one controlled area. If the brush no longer turns, the machine pulses with a clear airflow path, the battery or motor housing overheats, or suction remains poor, use the model-specific diagnostic or service route. External cleaning has then done its job: it has ruled out the common restrictions without turning a maintenance check into a repair attempt.
